The Best Price Boxes makes custom neck and shoulder rigid boxes with no minimum order, and we beat any written quote for the same specs. A neck and shoulder box is a two-piece rigid box: the base has a raised neck, the lid drops over it and rests on the shoulders, so the lid stops at a clean, even reveal instead of sliding all the way down.
How a neck and shoulder box is built
Both pieces are made from thick rigid chipboard, wrapped in printed or colored paper and glued at the corners. The base carries the neck, a narrower section that rises above the shoulders. The lid fits over the neck and lands on the shoulders. That ledge is the whole point. A plain two-piece box has the lid sliding fully down over the base; here the lid stops short, and you see a deliberate line of the base where the two parts meet.
It costs more than a folding carton and it does not ship flat, since rigid boxes are assembled at the factory. Plan your freight around that.
Custom neck and shoulder box specs
| Spec | What you get |
|---|---|
| Minimum order | None. Order one for a launch sample or a full run. |
| Construction | Two-piece rigid box, base with neck, lid on shoulders |
| Wrap | Printed or colored paper over rigid chipboard |
| Size | Made to your inside dimensions |
| Interior | Plain, or fitted with an insert. Ask us to confirm the insert type for your spec. |
| Finishes | Embossing, foil and similar finishes are options. Ask us to confirm for your spec. |
Where this style works, and where it does not
Neck and shoulder boxes suit products that get unboxed slowly: perfume, serums, candles, watches, tech accessories, gift sets. The shoulder gives you a place to seat a thin ribbon pull or a printed sleeve. See how it plays in cosmetic packaging, where the unboxing is half the sale.
It is the wrong choice when weight and freight cost drive the decision. A rigid box is heavy and bulky to ship, and for a low-margin item a mailer box carries the same product for a fraction of the freight. If you only want a lid-and-base look at lower cost, compare the two-piece boxes.
How to size one
Start with the product, not the box. Measure the item’s length, width and height, then decide whether it sits loose, in a tray insert, or in a custom insert. Give us inside dimensions and the neck height you want. A taller neck means a deeper lid reveal; a short neck looks flush but gives the lid less to grip. If the product has a cap or pump that sticks up, measure to the tallest point so the lid does not crush it.
Ordering
Send dimensions and a quantity, even one box. You get a dieline and a quote back, and we beat a written quote on matching specs. Design, samples and shipping are free. Look through the shoulder neck boxes, rigid boxes and white rigid boxes, browse the rigid box category, or go straight to the quote form. For finish options, read what embossing and debossing do.
Questions buyers ask
Is there a minimum order for neck and shoulder rigid boxes?
No. The Best Price Boxes has no minimum order, so you can order one box to check proportions and fit before ordering more. Send dimensions and a quantity and we send back a dieline and quote.
What is the shoulder on a rigid box?
The shoulder is the ledge on the base where the lid rests. It sits below the neck, which is the narrower raised section the lid slides over. It keeps the lid from sinking down and gives an even gap around the box.
How is it different from a standard two-piece box?
A standard two-piece lid slides fully over the base. A neck and shoulder lid stops on the shoulders, so part of the base stays visible. It looks more finished and tends to feel more deliberate to open.
Can I add an insert?
Yes. Inserts hold bottles, jars and sets in place and stop rattle. Tell us the product dimensions and weight, and ask us to confirm the insert material for your spec.
Who handles label or regulatory copy?
You do. For cosmetics, supplements and other regulated products, the buyer owns the label and legal copy. We print the artwork you supply.